A Plastic Gobo riding his Flaming Pony (Pixiv Fanbox)

Hi, y'all!

Here's my 3d printing journey update for October!

Continuing from last month's Goblin, I rigged him up, posed him and put him on Flaming Assfuck, the ponygirl^^

I did only 1 print on this one because this took 3 hours to print and I was cutting it close already^^".(I might try to print one as a miniature in a bit ;)) The tail stem of my print was too thin and snapped off so I had to use superglue to put it back for the one in the picture. I've fixed this in the STL file, so if you decide to print it then it should be good! (Hopefully) Use lots of supports as always!

Anyway, Hope you are well and stay awesome! STL file for the 1.1 version is attached!

Thank you once again for your amazing support!

YOU ABSOLUTELY ROCK!