Tenpower 60XG retest (production cell?) preliminary results (Patreon)
Content
Thanks to DIY500AMP.com I am testing a pair of July 31, 2026 dated Tenpower 60XG’s (date code ZG31) that are said to be production cells.
Why no CCC logo? It can be that they didn’t want to throw out all the pre-CCC wraps, they didn’t need to have them certified (test/evaluation or export-only cells), or that the client wanted cells NOW and the new wraps were not available yet.
There can be other reasons too but an important thing to remember is that the last pre-production (PP) cell revision, without CCC logo, is often exactly what the mass production (MP) cell will be (with logo). It’s just a wrap change. Unless there is a legal need for the logo (for insurance/liability reasons) then we can usually just look at performance.
The PP cells had Wh numbers a TINY bit higher than these MP cells but they are essentially the same (see graph above), no performance differences would be noticeable in use. Other small differences are…
These MP cells ran 3-4°C cooler in my testing for a continuous 40A discharge down to 2.8V. For almost every application though you will see no noticeable difference in temperature during use.
But because of this slightly lower temp I can raise the true continuous current rating from 35A to 40A.
These were 1.4g heavier (average) than the PP cells, weighing max 73.14g for two cells.
These MP cells are the same diameter as the PP cells but are about 1.5mm longer (max for my two cells).
These are more consistent for AC IR, DC IR, and capacity, exactly what I would expect for MP cells versus PP samples.
I don’t know if any date codes earlier than mine (ZG31) are also MP cells.
A general knowledge thing…on the wrap (image above) the full code is ZG313. The last digit is the manufacturing plant number.
The public full test report will be posted in a few days.