Welcome Pack! 🌺🌻🌼 Flower Power! (Patreon)

As promised... more flowers have bloomed! With it being spring time, I couldn't help but design a flower pack. After all, April showers bring May flowers!

This pack contains a variety of flower variations. I was obviously enjoying myself enough to go a little flower crazy while designing and I so hope you have some fun with these too!

-Kelly 🌺🌻🌼

Updates

04-14-25: Upgraded to the new base design

Flower Power Multi-Pack can be download at the bottom of this post 👇

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models have been tested with Kailh Bronze, White, Jade and White V2 clickers and the White clickers are my preferred option. I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).  A 7mm keyring file is included as well as a larger, 3.5mm diameter keyring hole to allow a beaded chain to be used!

Ok... This pack contains too many flowers!! Let me try to get everything listed off properly. For the single clickers, there are 3 raised caps, the hibiscus, forget-me-not, and sunflower as well as 2 flat caps, the hibiscus and forget-me-not. The two flat caps have an Extra White (EW) option that gives two layers of colors instead of just one if you need those colors to be extra bright. The bases for all 3 powerful flowers have a cute pot design! The hibiscus also has a BONUS contoured outline that I think would look cute in a green to make it look like the leaves on the plant. The single clicker bases are provided with the standard keychain configurations, none, 7mm and 3.5 diameter keyring.

Phew that was a lot! If you're still reading this, there is also a MULTI-CLICKER hibiscus flower that consists of SIX individual clickers! This design only has the one, flat cap design and all the flower pedals should be identical and interchangeable. The base on this multi-clicker contains two options, one for the 1in diameter binder ring keyring and one blank one. Ok done... I deserve a drink now!

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended for flat)

NOTE: I've found the best way to get the most crisp details on these clickers is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Accent Color (flower insides)

Primary Color (Flower Petals)

Everything else (base colors)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design.

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾

Flower Power Multi-Pack can be download here 👇