October '24 Exclusive: Crypt Clickers⚰️☠️ (Patreon)

🔒 Archived 12/01/24 - You can get this file from Cults3D or MyMiniFactory.

-------------------------------------------Hi friends! The last couple of days have been crazy with new supporters coming out of the woods and I cannot begin to tell you all how grateful I am for the support and how excited I am to continue to create fun designs to share with you all! To wrap up the Halloween clicker releases, we have a a slightly more grim release with our Crypt Clickers! This was a release that has been requested a handful of times and unsure of what direction to go with it, I just kind of started designing. I wasn't certain what I was going for so tried to go for a little bit spooky/grim and a little bit cute! I am so happy with how these turned out and hope you enjoy! ! ⚰️☠️

Crypt Clickers Multi-Pack can be found HERE!

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models have been tested with Kailh Bronze, White, Jade and White V2 clickers and the White clickers are my preferred option. I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).  A 7mm keyring file is included as well as a larger, 3.5mm diameter keyring hole to allow a beaded chain to be used!

There are 2 unique single clicker bases in this pack a tombstone base and a coffin base. The tombstone base comes with 20 cap designs and the coffin with 9 flat and 9 raised options in this pack. Each coffin base comes in the standard 7mm, 3.5mm diameter and blank keychain configuration. There is no keychain option included on the tombstone model but keychain holes are an approved mod and can be accomplished in most slicers by adding a negative shape!

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended for flat)

NOTE: I've found the best way to get the most crisp details on these clickers is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Small Detail (Coffin Details)

Everything else (Base Colors)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design.

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾

Crypt Clickers Multi-Pack can be found HERE!