Supporter Exclusive: Hoppy Surprise🥚🐰 (Patreon)

I'm back! With the promised subscriber exclusive variant of yesterday's FREE-ster Egg release! I knew I wanted to do the egg released yesterday, but I also really wanted to find a way to add a little extra festivity to it. The result of brainstorming was to add some bunny ears, bunny feet, and even an optional bunny tail that can be glued on! (There is also a flat tail option as well!) I am IN LOVE with how this guy turned out and am soooo excited to share these at our Easter Festivities this year! Hope you love them as much as I do! 🥚🐰

⚠️Note: These caps are 100% interchangeable with with FREE-ster Eggs so you can mix and match as you like! Also, there is a printed peg to help align the tail. You can scale this peg by a percent or 2 to get a tighter or looser fit depending on your specific printer!

Updates

03-02-25: Updated 3MF with painted ears and toes.

Hoppy Surprise Mulit-Pack can be found HERE!

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models feature a universal base design which has been tested with many keyboard switches and 99% of them work! I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).  

This pack contains 3 unique base designs (No tail, flat colored tail, and glue on tail) and 14 decorative caps. Raised variants are offered where able. Each base comes in the standard 7mm, 3.5mm diameter and blank keychain configuration.

Photo Colors 🎨

Orange - Amolen PLA Basic Carrot Orange

Purple - Hatchbox Midnight Purple PLA

Yellow - Polyterra PLA Savannah Yellow

Green - Elegoo Neon Green PLA

Blue - Overture Digital Blue PLA

Teal - Elegoo Sea Green PLA

Pink - CookieCAD Pixie Dust PLA

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

First Layer Extrusion Width (Initial Layer Line Width): 0.35mm (recommended)

Only one wall on first layer: True (recommended)

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended for flat)

NOTE: I've found the best way to get the most crisp details on these clickers is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Small Detail (Dots, Lines, Eyes)

Medium Detail (Eggshells)

Everything Else (Base Colors)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design (flat designs ONLY)

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾

Hoppy Surprise Multi-Pack can be found HERE!