Subscriber Exclusive: Click & Roll Multi-Pack 🎲🎲🎲 (Patreon)

Hiiiii! Today's release is more a Nick themed release than a Kelly one! Nick has been a big DnD fan for years and has wanted to do some DnD themed clickers since the beginning, but has been to busy helping with all of my logistical tasks required for running the Patreon. While Nick has been working on some of his more complex ideas, I thought it made sense to start simple with some clicky dice outlines! I think they turned out pretty ok, and Nick approved so hope you all enjoy them as well! 🎲🎲🎲

Click & Roll Multi-Pack can be found HERE!

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models feature a universal base design which has been tested with many keyboard switches and 99% of them work! I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).  

This pack contains 4 unique base designs and 8 cap designs. Each base comes in the standard 7mm, 3.5mm diameter and blank keychain configuration.

Photo Colors 🎨

Black - Yousu Galaxy Black PLA

Gold - Amoybaby Silk PLA Gold

White - Amoybaby Silk PLA White

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

First Layer Extrusion Width (Initial Layer Line Width): 0.35mm (recommended)

Only one wall on first layer: True (recommended)

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended for flat)

NOTE: I've found the best way to get the most crisp details on these clickers is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Small Detail (Numbers)

Medium Detail (Dice Lines)

Everything Else (Base Colors)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design (flat designs ONLY)

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾

Click & Roll Multi-Pack can be found HERE!