Supporter Exclusive: Rapid Cure Multi-Pack🩹🦠💉💊 (Patreon)

As promised, we have an expansion of yesterday's Feverish Freebie pack which includes a few bandages, syringes, and viruses with addition bases and faces - AND an additional SURPRISE DESIGN (Hint: the emojis might give it away 🤫) I am especially excited about the little viruses! I never thought I'd consider a virus cute, but I am soooo happy with how these turned out! Hope you all have some fun with these too! 🩹🦠💉💊

Rapid Cure Multi-Pack can be found HERE!

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models feature a universal base design which has been tested with many keyboard switches and 99% of them work! I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).  

This pack contains 5 unique base designs and 21 cap designs (+ a surprise 1 base and 8 caps). Caps are offered as raised variants where able. Each base comes in the standard 7mm, 3.5mm diameter and blank keychain configuration.

Photo Colors 🎨

Tan - Kingroon Skin PLA

Pink - Kingroon Pink PLA

Green - Kingroon Green PLA

Light Blue - iSanmate PLA+ Matte Blue

Dark Blue - Kingroon blue PLA

White - Kingroon White PLA

Black - Kingroon Black PLA

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

First Layer Extrusion Width (Initial Layer Line Width): 0.35mm (recommended)

Only one wall on first layer: True (recommended)

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended for flat)

NOTE: I've found the best way to get the most crisp details on these clickers is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Small Detail (Eyes, Mouth, Etc)

Medium Detail (Mask, Shapes)

Everything Else (Base Colors)

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker cap. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾

Rapid Cure Multi-Pack can be found HERE!