Welcome Pack: Emotional Clickers - Advanced Pack 2 (Patreon)

This is the second pack (of two?) that contains a wide variety of emojis.  I've been soooo excited to release these packs!  This particular pack is my personal favorite emoji pack thus far!  Add a keychain if you're feeling, and take them with you on life's adventures!  😘

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models have been tested with both the Kailh Bronze and Kailh White clickers but the White clickers are much nicer in my opinion. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process). The keyring hole is sized for a 7mm split ring. Due to a user request, I have also included a base with a larger keyring hole (3.5mm diameter) to allow a beaded chain to be used!

This pack contains 18 unique faces!

(all caps are saved as .3mf only)

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter: 0.33mm

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

NOTE: I've found the best way to get the most crisp details on the faces is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

White (Pupils/teeth)

Red (hearts/tongues)

Green (tongue)

Blue (tears)

Black (Eyes/mouths)

Yellow (Clicker base)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design. Some of the white details are very small and if you are having bed adhesion issues, you can always print them black and the face should still look good!

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾