Ring Tailed Lemur - Wildlife Kit Card (Patreon)

STL and 3MF files found here.

There are three parts to the jumping Lemur's stand; a post, an end cap, and the base.

Pass the post through the base and insert the post into the end cap. Then click the end cap into the base. These tolerances are tight to provide a secure fit, so be sure your printer and filament are calibrated properly prior to printing.

The body of the Lemur has two holes for the post to fit into. You will insert the post prior to adding on the leg of the Lemur. You can face your Lemur either direction. This is a loose fit, but once the leg is in place the post will not be able to come loose.

Fin