The Grinch - Christmas Kit Card (Patreon)

STL and 3MF files found here - Patreon Link

STL and 3MF files found here - Makerworld Link

Watch out everyone! There have been sightings of a potential Santa imposter roaming around.

People describe him as green and hairy and there are rumors it may be The Grinch!!

The Grinch uses push-fit connectors instead of the usual slide connectors.

Simply push the post through the hole in the body and then snap on the other arm / leg.

Due to print orientation, these posts can be more fragile than other pieces, so be careful when handling to avoid them breaking.

In order for The Grinch to stand, I have created a multi-part base that is integrated into one of the legs.

This uses two small connectors that are similar to previous designs slide connectors and you simply align the cutouts and push it all into place.

The 3mf file is set up for multi-color printing, with all recommended settings preset.

With the 3mf file you also have the ability to remove my branding and the kit card frame entirely by deleting the respective Object in the slicer.

The stl file is available for those who would prefer working with that file format.

Recommended Settings listed below.

Recommended Settings:

Elephant foot compensation set to 0 for better adhesion between colors

Wall generator changed to Arachne and transitioning threshold angle set to 20

Reduce infill to 10% and change to Cross Hatch

No brim or supports needed

Fin