Planter “Sylvatica Tree” (Patreon)

A unique Planter based on two species.

Tree: Fagus Sylvatica

Mushrooms: Formitopsis Pinicula

Versions included

Planter: The Planter

Planter_no_drainge: The Planter without drainage.

When choosing your version take into consideration the aging process of the print. The drainage water will inevitably color the saucer part with dirt and lime as all planters do. For me this is a nice patina, but you may prefer the print to stay clean.

Scaling / size

You can scale the print as you with wish from 60% to 100%+

Upscaling (100% +): as big as you want

Big (100%): 205 x 182 x 137 mm with an inner size of ca 95 x 95 x 134 mm and a wall thickness of 4 mm

Regular (80%): 164 x 146 x 110 mm with an inner size of ca 76 x 76 x 107 mm and a wall thickness of 3,2 mm

Small (60%): 123 x 109 x 82 mm with an inner size of ca 57 x 57 x 80 mm and a wall thickness of 2.4 mm

Print settings

Material usage (100%): 300g

Print time (100%): 22h

Material usage (80%): 180g

Print time (80%): 14h

Material usage (60%): 90g

Print time (60%): 7h

Material: PLA

Print direction: stls are rotated correctly, check images

Support: none

Nozzle size: 0,4 mm

Line width: 0,4 mm

Layer height 0,2 mm

Outer walls: 3

Infill: 15%

Build plate adhesion type: none

Watertight printing: If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), increase print temperature, check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.

Licensing

Individual purchases, free downloads and and all memberships besides the tiers that specifically allow for commercial use are for personal use only! Make sure to fully read and understand the License