Mushroom shelf “Fomes Fomentarius” (Patreon)

An organic shelf that “grows” from your wall.

If you need a small shelf for anything you want to make visible every day (like your favorite Benchy or a small plant) this is the one for you.

This one is is a combination of three 3d-scans of real fomes fomentarius that I found in the forest. Yes, it is upside down! Those grow the other way round.

Versions

Fomentariusfungus_shelf_default: The default size

Fomentariusfungus holderdefault: the holder for the default size with a screw-hole diameter of 5.5mm

Fomentariusfungus shelfsmall: A mini version (60% scale)

Fomentariusfungus holdersmall: A holder for the mini version – simply scaling down the default version would make the holder unusable

Fomentariusfungus shelfno_holder: The Shelf without the cut-out intended for scaling down below the mini version – must be mounted with glue or tape

Fomentariusfungus holderfor_upscaling: If you want a huge version, scale up the default shelf and use this holder – the only difference is the screw-hole size of 3mm that will be usable when scaled.

Instructions

Print the shelf and holder

You can either screw or glue it onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation.

Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks.

Enjoy!

Instructions fridge magnet

Magnet required: a 20 x 2 mm neodymium magnet

Internal magnet

The internal magnet shelf file has a cutout inside to place a magnet during the printing process. All mushroom wall shelf designs have the cutout at the same height – so you can print all of them at the same time.

Use a copper nozzle for printing (nonmagnetic)

Slice the file and check the layer height of the last layer before the bridging over the hollow cutout starts. With a 0.4mm nozzle it should be at layer 15. Implement a pause after that layer with your slicer.

Start the print

At the pause insert the magnet and continue printing. As always be careful with magnets and electronic parts!

External magnet

Print the file

Glue in the magnet after the printing process – the cut-out is sized to let the magnet stand out just a bit

Size default assembled: 152 x104 x 167 mm

Print settings

Required build volume: 170 x 170 x 110 mm

Material usage: 220g

Material: PLA

Print direction: stls are rotated correctly, check images

Support: none

Nozzle size: 0,4 mm

Line width: 0,4 mm

Layer height 0,2 mm

Outer walls: 3

Infill: 15%

Build plate adhesion type: none

Licensing

Individual purchases, free downloads and and all memberships besides the tiers that specifically allow for commercial use are for personal use only! Make sure to fully read and understand the License