Shenron Clicker [Archived] (Patreon)
Published:
2026-06-17 13:28:32
Edited:
2026-09-09 15:05:49
Imported:
Content
Hello Everyone!
A little dragon finally made its way into the clicker collection, but instead of granting wishes, this one just wants to be clicked.
A small print note: the teeth can be a little tricky to print and remove supports from, so I also made a version where the teeth are touching to make printing easier. I recommend doing a small test print first to see which version works best for you.
PRINTING SETTINGS
Printed Shenron at 0.16mm layer height
15% infill (Gyroid)
Supports are needed for the clicker hole, teeth and "hair"
Hope you like this little guy and as always thank you so much for the support! 💚