Home Creators Posts Import Register Favorites Logout

Downloads

Content

Hello Everyone!

I have a few more Halloween clickers to add to the collection. This time we have a cute little Vampire, a Cat Vampire and a Ghost Witch.

PRINTING SETTINGS

• Printed at 0.20 mm layer height• 15% infill (Gyroid)• Supports are needed only for the clicker hole and the Ghost Witch Hat

Download Hub <- Download the Vampire Clickers here!

The Ghost Witch will be available to download for free.

Hope you like them and as always thank you so much for your support ❤️

Files

Comments

TonyFingerz4

Are the supports already configured in the files or do I need to add them? Thank you

Makerize3D

Heya! Yes they should show up without need to add them but always make sure they are on :)

TonyFingerz4

Thank you, very new still learning but really enjoying it. Thank you for all your work.

TonyFingerz4

Sorry to bother you again, does one body print with a keychain hole? Just asking because there is an opaque tube in one, which I’m assuming is a negative or whatever they’re called(still learning) and it will not print that bit?

TonyFingerz4

Never mind, I see it now after slicing 🤦🏼‍♂️