Introducing HueForge Poke'Cards! (Patreon)

I am a BIG lover of Hueforge creations and art. I have been wanting to bring this to the table for you all to help share my knowledge of Hueforge, but also give you guys something different that you may not see with other Patreons. So without further ado, I give to you, THE Hueforge Poke Card to start the collection.Pinlup

Printing Instructions:Project: Pinlup Hueforge.hfp

Project: Pinlup Hueforge.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 80.03x120mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm

The Max allowed Thickness is 2.48mm and the Actual Thickness is 2.48mm

PLA+ Numakers Pitch Black Transmission Distance: 0.5

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA PolyTerra Fossil Grey Transmission Distance: 0.3

PLA PolyTerra Muted Green Transmission Distance: 0.3

PLA BambuLab Basic Blue Transmission Distance: 4

PLA BambuLab Matte Marine Blue Transmission Distance: 0.5

Numakers Cool White Transmission Distance: 2.3

Numakers Lemon Yellow Transmission Distance: 4.7

Numakers Bahama Yellow Transmission Distance: 3.8

This print uses 9 unique filaments

Swap Instructions:

Start with Pitch Black

At layer #6 (0.56mm) swap to Blue Gray

At layer #10 (0.88mm) swap to Fossil Grey

At layer #13 (1.12mm) swap to Muted Green

At layer #16 (1.36mm) swap to Blue

At layer #19 (1.6mm) swap to Marine Blue

At layer #22 (1.84mm) swap to Cool White

At layer #26 (2.16mm) swap to Lemon Yellow

At layer #28 (2.32mm) swap to Bahama Yellow for the rest.Now if you do not have these specific colors, you can still gain a similar looking image with some alternative matte colors. I love Numakers filament, its amazing for HueForges and 3d prints. I would recommend them 100%. Polymaker is an amazing second, and then the bulk budget friendly Bambu refills. IMPORTANT NOTE*** : Do not change the height of the card. You can scale it from side to side, but leave the height alone, or this will compromise the blending depth and you may not get the desired results. You also DO NOT need an AMS at all for this print. I have added pauses to the files for those who do have an AMS. If you do not, you can pause the print and the end of each color, before the swap. Cut your filament at the point where you start to feed it into the PTFE tube. This will give enough time for the color to finish it's layer and then switch to the new color. Prime towers are also not necessary. ***Ask any questions you'd like!P.s. The photo may look more grey in the slicer, I promise it will not come out with grey on top. I'm not sure why it doesn't show the white, but it will be much brighter and white where it needs to be. Print it and trust the process ;)

Find the Print file in the January Files Post!! See you on the other side!