Bunny in a cup (Fidget Clicker) (Patreon)

Say hey to the Floppy-Eared Bunny Clicker – cute, chill, and super fun to fidget with! 🐰💗Those floppy ears and clicky vibes make it hard to put down.Perfect for your desk, your bag, or just anytime you need a little stress bouncer! 🎯✨You can Download the .3mf file from hereImportant : Read Before Printing

For the best possible results with your finished clicker, strong bed adhesion is essential. We recommend thoroughly cleaning your print surface—whether that’s with soap and water or following your printer manufacturer's specific guidelines—before getting started.

Any Cherry MX Compatible Mechanical Keyboard Switches are compatible.You would need to Bend or Clip the Metal Contacts below the switches with pliers. (Only then the switches latch flush onto the base of the clicker)

Print the cap facing "Down" like in the picture provided. The mask details are raised a little bit on the cap.

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

First Layer Extrusion Width (Initial Layer Line Width): 0.35mm (recommended)

Only one wall on first layer: True (recommended)

CLICKER INFO Any Cherry MX Compatible Mechanical Keyboard Switches are compatible.You would need to Bend or Clip the Metal Contacts with pliers TESTED Switches. Kailh Box Thick Clicky Jade Switch Cherry MX Blues/ Reds / Browns Gatreon Yellow Linear SwitchesGlorious Panda Yellow Tactile Switches  

Filaments UsedBambuLab PLA Polymaker PLA