Superman S-Shield Fidget Clicker (Patreon)

Unleash your inner hero with this Superman-inspired fidget clicker – bold, iconic, and super satisfying to click! 🦸‍♂️✨

Important : Read Before Printing

DO NOT SELL COMMERCIALLY AS I DO NOT OWN THE IP

For the best possible results with your finished clicker, strong bed adhesion is essential. We recommend thoroughly cleaning your print surface—whether that’s with soap and water or following your printer manufacturer's specific guidelines—before getting started.

Any Cherry MX Compatible Mechanical Keyboard Switches are compatible. You would need to Bend or Clip the Metal Contacts below the switches with pliers. (Only then the switches latch flush onto the base of the clicker)

Print the cap facing "Down" like in the picture provided. The mask details are raised a little bit on the cap.

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

First Layer Extrusion Width (Initial Layer Line Width): 0.35mm (recommended)

Only one wall on first layer: True (recommended)

CLICKER INFO

Any Cherry MX Compatible Mechanical Keyboard Switches are compatible. You would need to Bend or Clip the Metal Contacts with pliers

TESTED Switches.

Kailh Box Thick Clicky Jade Switch Cherry MX Blues/ Reds / Browns Gatreon Yellow Linear Switches Glorious Panda Yellow Tactile Switches