3D Text Edge Bookmarks Part 2 (Paid) (Patreon)

UPDATE: I have now added a V2 that has the "i" and apostrophes included, by welding them to the adjoining letters. You can grab this from the Download Post linked below.

Following on the previous set, here is part 2 of the 3D bookmarks! 📚

Phrases included in this pack:

Someone Yelled Mom

Someone Yelled Mum

Shut Up I'm Reading

Go Away I'm Reading

Not Now I'm Busy

Be Right Back

I have one more set of phrases to be released and that should be the collection completed (unless I get more word requests haha).

Also included this time is an edge bookmark holder in the shape of a book! I was doing a vendor event recently and was thinking that these don't display all that well in a traditional bookmark stand. I did bring a book to display them with but it only fits one so I decided to make a holder to showcase a few more phrases! You could also use them as a display on your bookshelf. 📖

There's two versions, a single book holder (fits one) or a double sized one (fits two). To make them easier to stack I included a modular cover for both versions, you will need one top cover, one bottom cover and as many middle covers as you want. The covers have an indent to help them sit on top of each other neatly but THIS IS LOOSE WHICH IS INTENTIONAL for unpacking reasons! If you want them to be secured, you can choose to glue them. You can also use double sided tape/velcro if you want them to be more secure but not be permanently fixed together. Alternatively you can just print the single cover version and stack those. Completely up to you, whatever works best for your own set up!

The page section in the middle is the same piece throughout each version and should slide in with with a nice snug fit. If it's loose or you're worried about it coming part you can choose to glue the pieces together as well. The correct orientation of the page piece is the larger size on the UP SIDE, this is due to the height of the letters of the bookmark being taller on the upper side. Some text will not fit unless it's the correct orientation.

Disclaimer: please also note that these holders are designed to fit the edge bookmarks I designed specifically as they use a certain height and thickness, therefore I cannot guarantee they will fit other edge bookmarks.

This holder is also available with the part 1 bookmarks FOR FREE. If you purchased the file on Etsy/Cults please go to your purchases to redownload the file as it will now contain this holder.

If you were a subscriber the month these were released but are no longer subscribed and would like the holder file please send me a message with your email and I can send these directly to you (must be a March or newer subscriber).

For the bookmarks print settings wise I suggest slowing down the print in general, especially at higher layer heights (I printed at 100mm/s) to reduce any wobble as it's a relatively thin piece. For the decorative holders I also suggest a lower infill to reduce filament usage (I used 7%) to keep them lightweight and easy to bring with you.

Members can download these from the Download Post or from the below link:

https://www.patreon.com/posts/141467724/

It's also available on Etsy/Cults if you'd like to just buy it for a one time fee (commercial license included).

Etsy: https://www.etsy.com/listing/4511291284

Cults: https://cults3d.com/en/3d-model/home/text-side-edge-bookmarks-bundle-02