Troubleshooting FAQ — Patreon issues + Printing/Slicing problems (Patreon)
Content
1. Patreon issues
I was incorrectly charged, or I cannot access my benefits after paying.
Payment issues and access problems are exclusively handled by Patreon. Submit a ticket to the Patreon support team here: https://support.patreon.com/hc/en-us/requests/new
2. Slicer and file issues
The files have no color.
Be sure you are opening the 3MF file in your slicer and not the STL files. Only the 3MF file contains my color data.
The print time seems crazy long.
Some multicolor designs may appear to take a lot of time when you slice them using an AMS-based printer. These designs are best printed with many clones on a single plate. This spreads the filament swapping time across many pieces. Alternatively, consider upgrading to a toolchanger machine like the Snapmaker U1.
For example, a single design may show 4 hours of filament swapping, but adding one clone to the plate may only increase the total print time by 15 minutes.
3. Print failures and visual quality issues
My prints became spaghetti, moved during printing, or are warped.
Wash your plate with degreasing soap, hot water, and a dedicated (no food use) abrasive sponge. Isopropyl alcohol is good, but degreasing soap is always better. If you print on a PEI plate, a sticky cool plate upgrade is highly recommended. I personally use BIQU Cryogrip Frostbite plates.
My prints have a big layer shift.
Your printer may need belt tensioning maintenance. Google "belt tensioning" for your specific printer model. Print speeds may also be too fast. Consider slowing down.
My prints are ugly on overhang areas, or mechanical sections are fusing together.
Adjust settings in your slicer to improve overhangs.
1. Set wall count to at least 3 walls
2. Set wall print order to inner/outer
3. Set part cooling fan to 100% fan speed
4. Enable slow down for overhangsThe above settings usually fix it. If the prints still look bad (or fuse), continue below.
5. Under slow down for overhangs, reduce speeds to 30mm/s or less
4. Assembly and durability problems
My printed keycap broke off so easily.
This can happen with weak PLA types.
• Weak: matte, glitter, marble, glow-in-the-dark, wood-filled, CF-filled
• Medium: silk
• Strong: regular, pro/plusAvoid weak PLA types for the keycap, particularly the cross-shaped (+) part.
My printed keycap doesn't fit onto the clicker (keyswitch).
Lower your filament flow ratio setting in the slicer. Defaults are usually around 0.98. Reduce this to 0.97 and run a test print. Repeat until the keycap fits well.
My printed keycap is too loose and falls off.
Increase your filament flow ratio setting in the slicer. Defaults are usually around 0.98. Increase this to 0.99 and run a test print. Repeat until the keycap fits well. Optionally, some people prefer to use superglue instead.