Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

It’s clean. Very very very clean. Cleaner than when I had duet installed.

Some notes. This was my Duet Bear so 0.9 degree XY, geared bear extruder with LDO geared motor, plus some nice parts. Still has stock PSU, e3dv6, and bear parts.

Now that I have this working I’m going to run test prints while I’m downstairs in case of tragedy. Once I think it’s safe I’ll run a longer stress test print and share this firmware as well as the Prusa Slicer profile I made.

I ordered another board and will swap it to a 1.8 degree XY Prusa and compare. So far results are promising and I’m super stoked to keep pushing forward.

The prints so far have a mirror finish. Zero moire and zero typical 602. You can see very minor uneven extrusion but it’s fdm and we will never not have it to some extent BUT it’s soooo clean. Cleanest I’ve ever seen.

Stay tuned for more updates!!

Files

Previews only

SKR V1.4 Prusa test cube

First test cube off the SKR prusa after tuning motor currents. Printed with regular FilamentOne Blue PLA

Comments

No comments found for this post.