🩷Monday MagBuddy Drop! Pumpkin, Skeleton & Witch Kitty🐈‍⬛🎃 (Patreon)

Three spooky little cuties are joining the MagBuddy lineup just in time for Halloween!

We’ve got a Pumpkin Kitty, a Skeleton Kitty, and a Witch Kitty — each with their own totally different personality! One shy one, one ham, and one who might actually be magic.

(I am working on slasher kitties and will be dropped later as free bonuses for Patreon members!)

Thank you again for loving our little creations and happy printing!!

🧲Magnet Placement Pause

These prints include a pause for inserting 8×2mm round magnets. These are the ones we use→ https://amzn.to/46b4go9🩷If you prefer no magnets, simply delete the pause and let it run through!

⚙ Quality

• Layer Height: 0.16mm... (The smaller the layer height, the higher the quality. This is your choice. We use .12 to .16, 99% of the time, if you want to save time, make this number BIGGER). I don't recommend anything over .2 for these models.

💪 Strength

• Walls: 3• Infill: 9% **6% infill for Pumpkin Kitty• Pattern: Gyroid

🚀 Speed

• Outer Wall: 200mm/s• Inner Wall: 200 mm/s• Sparse Infill: 200 mm/s• Internal Solid Fill: 200 mm/s

*Top Surface: 200mm/s (100 if using silk filament); otherwise 150 to 200 is good• Overhang Speeds: 20 / 20 / 20

🌳 Supports

• Type: Tree• Style: Default• Support Angle: 10• On Build Plate Only: Yes-->> Critical for supports to NOT fill your magnet hole• Top Z Distance: 0.28• Bottom Z Distance: 0.28• Base Pattern: Hollow

🔧 Other Settings

• No Brim• Purge into Object Support: No• Flush Multiplier: 1.3x

💖 All settings are suggestions.

These are the settings I personally use and recommend to achieve the quality shown in my photos. However, every printer and user is different, so feel free to modify them as needed to best fit your setup and printing preferences.

💬 LicensingThese files include a commercial license for active 3D Misfits patrons. You may print and sell physical items. Redistribution, reselling, or sharing of STL files is strictly prohibited.