Home Creators Posts Import Register Favorites Logout

Content

The build is complete and now I'm trying to calibrate the bed/auto-level sensor. The firmware does some back and forth movement at first 4 spots and then 9 points. If the paper moves I have to adjust the probe. So far I've had to adjust the sensor twice. Hopefully this time works. This is the most advanced auto-level I've ever worked with.

Files

Prusa Calibration

Comments

Bill Karkula

I ordered sensors with the intent to add auto-leveling to my Prusa clone, a CR-10 that is on order, and an Anycubic Delta that I am in the middle of building. From Chuck's experience so far and from the comments, it looks like once you get over the initial setup it works well. Now that I have been printing for a while and have my settings dialed in, I'd love to be able to walk up to the printer, load gcode and go without worrying if the printbed is still level. For me it's becoming more and more about what I am printing and less about tweaking the printer. One question: Does the Prusa indicate if it is unable to level the bed if it is possible for the bed to be that much out of level? I'm thinking if the bed is so low that the extruder can't reach it for the first layers.

Anonymous

I've had to readjust the probe on my MK2S after installing a tungsten nozzle, which is a bit taller than the stock E3D nozzle. Ever since, every first layer is just perfect, with a live Z adjust of less than -0.300 mm. I've ran all of the printer's calibration routines, including PID and temperature calibration. After some issues, however, I've deactivated the latter, since heating the PINDA probe gave me some inconsistencies with live Z adjust doubling after every print.