Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

My wife asked me if I could print the Niffler from the movie Fantastic Beasts And Where To Find Them. She found the model on Thingiverse and I said no problem. But then she asked if I could print it 1 1/4" tall or 32mm. The design is originally 130 mm tall so I wasn't sure how well it would shrink. Then she asked if I could print it on the CR-10 because I've been showing her how good it prints. So that was the challenge; could I shrink it, slice it and print it on my largest machine successfully? So far so good. The picture shows 1", 1 1/4", 1 1/2" tall at 0.1 layer height (1") and 0.2 on the rest. They are 30% fill using Inland black PLA at 215c and 40c on the bed. 40 mm/sec print speed. I did use a raft and supports and sliced with Simplify3D.

Files

Previews only

Comments

3D Print Creator

Unbelievable how nice that machine prints... Really, for the price of that machine... It's unbelievable good !!!

Anonymous

Chuck, you should know rule number 1 of 3D printing: Always link to the model you are demonstrating. ;-)