Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

The ABS filament I've been using in the MP Select Mini decided to go for a twist. Very strange as the nozzle wasn't even blocked. It just stopped printing and this is what I found when I removed the fan and pulled out the Bowden tube.

I simply cut the opposite end near the spool and pulled it through the twisted end. I then reinstalled everything, loaded the same filament and it was printing again.
I have never seen a failure like this.

I put a small section of PTFE tube in that gap on one of the other minis I have but that just created more clogging problems than it solved since it was too close to the heat. The fan is not the best in this little printer.

Anybody ever see a failure like this?

Files

Previews only

Comments

Anonymous

Could it be a retraction setting issue? kind of looks like what i would imagine flexible filament would do and i have heard retraction settings are crucial. Just wondering if you have been playing with settings. If so maybe reload the stock fff file and try again

Anonymous

No issues with mine now after seven months of use. Have used ABS/PLA/PETG - no glogs & certainly nothing like that. Not sure if this is a V1 or V2 and have yet to remove the fan to see what is behind it. Not going to mess with it till I need to. Could be a nice way to make a plastic spring ........

elproducts

No, it's been printing the same file for months 24/7. Just started seeing this issue.