Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

The Anet E10 would not reach the starting temperature so it wouldn't start printing. At first I tricked it by over-riding the settings to a lower starting temp and then raised it after the print started. But today it was even worse so I found that putting two strips of electrical tape across the fan opening allowed the hot-end to heat up but not over-heat. It's now printing really good and maintaining temperature of around 215C. I posted this to YouTube quickly so others who may be fighting this can get a quick fix for themselves. I know I was pretty frustrated. It even caused the nozzle to get jammed with filament and I couldn't get it hot enough to clear it. I had to replace it with the spare nozzle they included in the box.

Full review is coming for Filament Friday.

Files

Previews only

Anet E10 3D Printer Temperature Trick

Chuck gives you a quick tip on getting the Anet E10 3D printer to reach temperature. The printer out of the box doesn't reach full temperature so the print wont start. He shows you a simple fix to get around this issue and how to get prints running on your E10.

Comments

Anonymous

Man they sure cut a lot of corners on that printer. Thanks for the tip!

JAT.MN

Wow.. cant even get to temp properly out of the box? *sigh* hope the rest of this review goes better.. thx for the tip off