Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Downloads

  • PartsDrawer.stl
  • PartsDrawerCase.stl

Missing 1 full-res photo, 2 files, as this post has not yet been imported.

Content

I used the E10 again to print this custom nine drawer storage cabinet. Simple Tinkercad design. Check it out. Files are attached here so you get them before I post them on Thingiverse.

Files

Previews only

3D Printed Hardware Parts Drawer Cabinet

Chuck designs and 3D prints a parts drawer cabinet for some electronics components.

Comments

Bill Karkula

Another useful practical print example. I just finished making very large two position drawer units that each took almost an entire roll of filament and around 33 hours each to print on my CR-10 (and I jacked up the print rate to 200%) but they are exactly the size that I needed. I made seven of them. I am very happy with the results. I have a parts drawer carousel and will mod this drawer STL to make some customized divided section drawers for specific parts. Organization is fun when you can make the storage fit your needs exactly.

Brian Popilek

Hey Chuck, where did you find that electronic parts kit? I'm actually headed to Microcenter this morning and wanted to see about picking one up while I was there. Thanks.

elproducts

Sorry I didn't see this sooner. It's in their electronics area with the Arduinos.