Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Started a print and didn't check Filament level ..doh! Ran out of filament mid print. Anycubic wins this round with its built in filament sensor.

Files

Previews only

Comments

Norbert H. Davis

Chuck, I thought you did a low filament sensor before? If anyone had them in use I thought you would just because you have the units that you run all the time for production. This is an awesome opportunity for you to make a video (or two) and a product. What about a filament sensor that sounds an on board (or remote) physical alarm (with volume control) AND will notify you via SMS? Now there is a project the entire 3D Printing community could get behind! Then if it works well enough (any doubts - no) then do a Kickstarter for it!! I would rather purchase one or three from you than some other company.

Anonymous

How about a filament counter? I usually write on a tape the lengths I print and tape it to the reel. There could be a tiny counter that keeps track for me..