CR-10 Mini Bowden Tube Issues (Patreon)
Content
The Mini has the same bowden style setup as the full size CR-10 with the same extruder and hot-end. I was able to print several smaller prints with success and the quality looked as good if not a little better than the full size CR-10. Then I tried to print a large flat print and the trouble began. The PLA filament would jam up inside the bowden tube after only a few layers.
It appears as though the PTFE tube is getting too hot down inside the hot-end and thus allowing the PLA to expand. This caused the filament to lock up and not flow out of the nozzle. They supply the printer with an extra bowden but that one did the same thing.
I decided to try a premium bowden tube that I got from Midwest RepRap Festival (MRRF). The company is Capricorn. With that bowden tube installed, I was able to complete a large print without the filament getting jammed.
I'll have a full review in the future but so far this jamming bowden is really a pain. Maybe it's just a bad batch of PTFE tubing. I'll keep testing to see if the Capricorn PTFE works.
Files
Previews only