20 Hours+ on Tevo Tornado (Patreon)
Published:
2017-10-05 14:21:39
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
I had a big roll of Pink Filament and my daughter had asked me many months ago if I could print a large Eiffel Tower for her. I found this one:
https://www.thingiverse.com/thing:1276837
It says it was reworked to make it easier to print and it seems to be doing fine. I resized it to 220% at 0.3 layer height and 10% fill. 2 outer layers.
Simplify3D was way off on this one claiming it would take 19 hours to print. It's at 20+ and still a couple hours left to print.
The Tevo Tornado seems to be handling it fine. It's a bit rough in spots so I know the S3D profile and probably some firmware settings need adjusting but the printer is working well after an intial rough start.
https://www.thingiverse.com/thing:1276837
It says it was reworked to make it easier to print and it seems to be doing fine. I resized it to 220% at 0.3 layer height and 10% fill. 2 outer layers.
Simplify3D was way off on this one claiming it would take 19 hours to print. It's at 20+ and still a couple hours left to print.
The Tevo Tornado seems to be handling it fine. It's a bit rough in spots so I know the S3D profile and probably some firmware settings need adjusting but the printer is working well after an intial rough start.
Files
Previews only