Prusa Repair Continues (Patreon)
Published:
2017-10-25 00:12:00
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
The Prusa MK2S repair is becoming a nightmare. I figured replacing the temp sensor would be easy but it wasn’t. The hot end block was all messaged up. The set screw that holds the temp sensor was too tight and the hex head stripped. I tried remove the heat element to replace the block and that screw would not budge.
Luckily I had a full spare actual E3Dv6. I stole the heat block, heater element and temp sensor. I replaced it all and re-routed the wires. Everything worked great and I got it to load and extrude plastic.
Then I found out the auto-level kept driving the nozzle up not down. On our there examination, I apparently broke the Pinda sensor when removing the blob of plastic. It should had a black tip and mine doesn’t anymore.l (as seen in picture).
It’s a special 5v version so I had to order a new one direct from Prusa. Probably a week or more before I’ll see that.
I’ve never really liked auto-level but it worked well on my Prusa until the blob. Now I’m beginning to hate it again. I wish there was a backup mode so I could manually level and print.
Now I wait.
Luckily I had a full spare actual E3Dv6. I stole the heat block, heater element and temp sensor. I replaced it all and re-routed the wires. Everything worked great and I got it to load and extrude plastic.
Then I found out the auto-level kept driving the nozzle up not down. On our there examination, I apparently broke the Pinda sensor when removing the blob of plastic. It should had a black tip and mine doesn’t anymore.l (as seen in picture).
It’s a special 5v version so I had to order a new one direct from Prusa. Probably a week or more before I’ll see that.
I’ve never really liked auto-level but it worked well on my Prusa until the blob. Now I’m beginning to hate it again. I wish there was a backup mode so I could manually level and print.
Now I wait.
Files
Previews only