Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Fun King asked about the surface finish of the Ultrabase while others referred to PEI. Here is a simple clip print at 0.3 layer height printed on Prusa PEI (left) and Anycubic Ultrabase (right).
I had to angle the camera a bit to get the reflection to show the circles on the Ultrabase. They both stuck down fine. The PEI was a little harder to remove after the bed cooled.

Files

Previews only

Comments

Fun King 3D

That is not bad at all. I kind of like it. I don't like the shiny you get from printing on plain glass because you only get it on one side of your print. This adds just a little "texture" to the surface. I am going to pick one up for the Anet. Thanks Chuck!

elproducts

A little glue on a glass bed not only holds it but often dulls that shiny surface. With the Ultrabase I rarely use glue.

Anonymous

Very nice! Thanks for running the comparison. 3D printing just keeps getting better and better.