Tevo Tornado (Patreon)
Published:
2017-11-12 13:02:12
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
I’ve taken my time to review the Tevo Tornado. I’ll be traveling next week so I’m not sure when my full review will be done but overall I like it. I prefer printing on glass directly but the included Tevo bed sheet seems to work well and it’s on top of what appears to be a glass surface.
It’s a copy of the CR-10 in many ways including a single threaded rod for Z. This is no different than the Tevo Tarantula I reviewed a couple years ago. So they did that before CR-10. Even the brackets are the same shape as the CR-10. The hotend is a bit different and the extruder has a gearing system for more torque I believe, but the cooling fan setup is very similar,
The bed uses low voltage AC and heats up quicker partly because it has an insulation sheet under the bed. Not sure AC helps that much but can produce more average power and even current in both directions on the heat plate. I have to study this more as it’s unique.
Print quality is decent. The Phil-a-ment astronauts and the pink Eiffel Tower were printed on it.
I still kind of like my original CR-10 better but I can’t exactly tell you why as they both seem to deliver really good prints and work well.
It’s often a bit cheaper than the CR-10 so that’s an advantage. Overall I can recommend it but give me more time to finish my review. I just wanted my Patreon supporters to get the inside scoop.
It’s a copy of the CR-10 in many ways including a single threaded rod for Z. This is no different than the Tevo Tarantula I reviewed a couple years ago. So they did that before CR-10. Even the brackets are the same shape as the CR-10. The hotend is a bit different and the extruder has a gearing system for more torque I believe, but the cooling fan setup is very similar,
The bed uses low voltage AC and heats up quicker partly because it has an insulation sheet under the bed. Not sure AC helps that much but can produce more average power and even current in both directions on the heat plate. I have to study this more as it’s unique.
Print quality is decent. The Phil-a-ment astronauts and the pink Eiffel Tower were printed on it.
I still kind of like my original CR-10 better but I can’t exactly tell you why as they both seem to deliver really good prints and work well.
It’s often a bit cheaper than the CR-10 so that’s an advantage. Overall I can recommend it but give me more time to finish my review. I just wanted my Patreon supporters to get the inside scoop.
Files
Previews only