Tevo Flash (Patreon)
Published:
2018-08-10 22:55:10
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
Tevo sent me a Flash to play with. Mine has the upgraded dual z rods/motors and BLtouch autolevel. Seems to level pretty well once I got it setup. It was really easy to put together. Four screws for the upper section (like CR-10) and a few connectors.
Like the Tevo Tornado, no spool holder or sample filament is included which surprising.
The first sample print came out fairly smooth. I may also have the upgraded TMC2100 drivers but I’m not sure yet. May have to remove a panel and investigate.
The picture shows the first sample print. I’m not sure what it is to be honest.
The instructions explain how to upgrade the firmware. It’s running Marlin and has a Mega2560 according to the Arduino setup.
This price ranges from $239 to $369 depending on the features you choose.
BLtouch ($50)
Dual Z ($30)
TMC2100 drivers ($50)
Are the upgrades according to the Tevo website.
https://tevo3dprinterstore.com" rel="nofollow noopener" target="_blank">https://tevo3dprinterstore.com
Like the Tevo Tornado, no spool holder or sample filament is included which surprising.
The first sample print came out fairly smooth. I may also have the upgraded TMC2100 drivers but I’m not sure yet. May have to remove a panel and investigate.
The picture shows the first sample print. I’m not sure what it is to be honest.
The instructions explain how to upgrade the firmware. It’s running Marlin and has a Mega2560 according to the Arduino setup.
This price ranges from $239 to $369 depending on the features you choose.
BLtouch ($50)
Dual Z ($30)
TMC2100 drivers ($50)
Are the upgrades according to the Tevo website.
https://tevo3dprinterstore.com" rel="nofollow noopener" target="_blank">https://tevo3dprinterstore.com
Files
Previews only