Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I tried Ninjaflex Filament on a stock Ender 3 and the filament jammed up. I changed the extruder to the SeeMeCNC EZR and am trying it again. So far it seems to be working better as it limits the filament from getting out of place. I’m printing at 230°C, 10mm/sec and no retraction. I’ll let you know how it turns out.

UPDATE:
I compared this EZR to my Artemis and the Artemis EZR has a PTFE tube inside the exit path and the one I installed on the Ender 3 does not. It's still working but I can see some twisting. I contacted SeeMeCNC about to see if I got a defective unit.

2nd UPDATE:
It was my screw-up. The PTFE tubing is suppose to push all the way into the stop by the gear. My tubing was stopping short inside the metal push/lock connector block. SeeMeCNC corrected me and said it should push all the way through. I've got that fixed now so good news, it's printing again.

Files

Previews only

Comments

Brandon T

One trick to printing flexibles on a standard (non-flexible-"optimized") extruder is to set your print speed to be constant throughout the print - don't drop it for outer shells/bottom/top layers, etc, just get it going at one speed and leave it there. If you still get jams after that, it makes it easier to troubleshoot since you can do things like just adjusting your flow rate to try and get the filament feeding in at a rate where it doesn't get pushed in faster than it's coming out, etc. Another trick/solution I found to SemiFlex causing repeated jamming issues on a particular model was to (in S3D) actually turn on a LOT of retraction (4mm in my case) forced each layer, but with a tiny extra restart distance (0.05mm in my case). That way it would release the ever-nearing "bent filament jam" but that extra little restart gave it just enough post-retraction pressure to prevent any gaps when the next layer started.

Anonymous

You may have one of the older ones, or vice versus. Performance was the same and the only noticeable difference I found was feeding new filament occasionally would snag which was easily overcome by chamfering the inlet. People underrate these EZR extruders and I found them to be great performers for the price. One item I don't like is that stupid knob is crap, they need to bring back the nylon gear or use a metal knurled knob (similar to a nice old volume knob on a receiver)