Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I’m trying out a 1mm nozzle on my SeeMeCNC Artemis. I printed a couple cats at 0.8 layer height. They are pretty rough. The yellow is 300% (~3hrs) and the pearl is 200% (~ 45minutes). I can’t go above 30mm/s or I start to hear clicking in the extruder. I may try a higher temp than 230°C to get a higher speed.

Thanks to Patreon supporter Jim Carter for the S3D profile to get me started.

Files

Previews only

Comments

Anonymous

I have tried 1mm nozzle on my ft-5 but found I don't like how the prints look. I went back to .4mm and just deal with the time it takes .

Anonymous

Chuck, I hope you do a full video on this. I love when youtubers do this experiment! It finally got me to the point where I was comfortable with trying it. 1mm was fun to play with, but I settled on a .6 nozzle since it gave me a good mix of speed and detail (at least for the stuff I tend to do).