Fabrikator Mini Can Print Without A Computer! (Patreon)
Published:
2015-09-29 18:25:35
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
I finally was able to get the Fabrikator Mini setup with an LCD and SD card module that allows me to print without a computer connection. A minor change to the Marlin firmware was all it needed (was what I was told). I spent hours reflashing the board and checking the code. I could not figure out what I was doing wrong. Then I googled and found another required step that I learned from a subscriber of my YouTube channel. Subscriber XBLmonster, in his YouTube video, said he had to put the cable connectors in backwards. In order to do that you have to cut off the locators and then insert them into the board backwards.
I did that and the LCD lit up showing the screen in the picture above.
Who would have thought the connectors needed to be inserted backwards?
Certainly not me. I'm going to check if the ribbon cable was inserted into the connectors incorrectly because this was too strange. But thanks to XBLmonster sharing his knowledge, I'm printing without a computer.
This little Fabrikator Mini gets better and better. Now to document the steps for a future video.
Files
Previews only