Home Creators Posts Import Register Favorites Logout

Content

I had to travel for work and that put me into crunch time for Filament Friday and CNC Sunday but I got it done. I'm back and return to a normal schedule.

We picked up a few more Patreon supporters during my week away. I should go away more often. Welcome and Thanks for the support.


I'm having problems getting prints to stick to the bed of my Re-Flashed Da Vinci 1.0A bed. At one point I had about 5 layers of glue down and that worked. Made for some ugly bottom prints. The Fabrikator mini has shown me that rafts can be useful since it doesn't have a heated bed. I may try experimenting with rafts again and compare the different slicers. Even a perfectly clean bed with properly adjusted height is occasionally lifting prints and sticking to the hot end. This printer rarely did that before. I've never tried the ABS glue where you mix a little abs with acetone to make a sticky base. It may be time to try it. Can't figure out what changed.


In the past, I've had terrible luck getting good prints out of Simplify 3D and couldn't figure out why I was the only one not bragging about S3D. One of the users on a Fabrikator mini forum (http://www.rcgroups.com/forums/showthread.php?t=2469638)  gave me his settings for using it with Simplify 3D. I had to tweak it a little but I've finally gotten S3D to work for me. All previous attempts were not worth mentioning.  Fact's be told though, I'm getting just as good of prints from Slicer so I assume there is more I can do to improve my experience with S3D.


I may put those settings on my Fabrikator Mini page.


I also have my add-ons to the Fabrikator Mini on the site in Puzzle cut form so you can print them on the mini. I just haven't tested them yet. If anybody does, let me know your results.

Comments

Anonymous

Here in the UK I use a product called 3-D Lac. Specifically on heated glass beds and absolutely on a Da Vinci Fragile glass bed. it dries while the bed is heating and becomes "sticky" after printing when it cools you can hear the print pop off, you don't use a lot and it only requires a bit of a dusty touch up now and again.

Anonymous

I get it from a guy called Tim Grey from technology outlet, it is produced in Spain but I believe it is available all over, if you cant find it I will send you some.

elproducts

That would be expensive from UK. Let me search around first. Thanks for the offer.