Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Downloads

  • Video Dec 23, 10 37 31 PM.mp4

Missing 1 full-res photo, 1 video, as this post has not yet been imported.

Content

I've spent a couple weeks trying to get my new WanHao Duplicator I3 working properly but time ran out. I narrowed it down to an issue with the temperature control that I could not fix. Rather than go through a whole series of back and forth with the tech support, which would be worse as I bought an unbranded version through monoprice.com, I decided to just return it within the 30 day time frame.

As you can see in the attached video, the temperature would not stabilize no matter what I did. I tried every adjustment I could find. In the end it left ABS prints split and PLA prints rather rough.


I further discovered that most of the top reviews for this printer were with PLA but a lot of ABS issues. I want a printer that can do both well and this didn't meet the challenge.

Files

Previews only

Comments

Karl Nowakowski

By and large I am very happy with it, it's the version two design. There was some damage on arrival, which seams quite common. Nothing major though and all fixable, the z limit arm had come off, the plate under the head bead was bent meaning I needed to add washers under the adjustment springs to enable bed levelling , minor damage to one of the cable chains and one loose screw in the box that I still haven't found where it belong. Bed Levelling seams to be quite touchy but that might be the operator. The bed and extruder temperature seams to float around a lot (which I read that some people complain about on reviews) but I thing that is more the lack of some form of averaging from the sensor as apposed to true floating as it can very by as much as 10 to 15 degrees in a couple of seconds. Once I've finally got the bed level its producing good quaint pla and abs prints.

Anonymous

That's a shame. I got a Wanhao I3 directly from Wanhao and it prints great. I was able to stabilize the temps (somewhat) and it prints better now. I was looking forward to tips with your Wanhao but that's ok. Thanks for all the great videos!

elproducts

It's not over yet. I'm suppose to get one direct from WanHao to try out so I may still get one on the channel.