Homing Test on Re-Built Sunhokey 3D Printer (Patreon)
Content
So I bought some 2020 Aluminum extrusion and built a new frame. Then started with some 3D printer brackets from Thingiverse.
I had to modify most of them in Tinkercad to fit the Sunhokey spacing but it was a great starting point. I started with the mounts for the Y-Axis 8mm rods and mounted them to the frame. The Y-axis moves very smoothly so that was a good start. Next I printed Z-axis Stepper Motor mounts with built in rod guides. I also printed upper supports for the upright 8mm rods. This took some adjustment to get the spacing right for a smooth Z-axis movement.
The X-axis had a home switch but the Z-axis needed a new mount so I modified one of the Thingiverse stop brackets and created a new bracket for the Sunhokey Z-axis home switch.
I decided to see if everything would work before tackling the Y-axis. I hooked up the electronics and tested out the X and Z movement by using the Auto Home feature in the LCD control. Here is a short video of the X-axis and Z-axis going to home position. I'm manual pressing the Y-axis switch so it doesn't delay in the video.
This was also a test of posting Patreon only videos for my supporters. I hope to do more of these in 2016.
Files
Previews only