Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Six hours into the build and down to the wiring next. The Arduino module and shield are mounted and so is the power supply. The stop switches are in place and the motors are mounted. The switches have harnesses so that is easy. The motor wiring is also prebuilt harnesses. So my concern about a bunch of soldering was not an issue at all. The only soldering looks like the wiring for the heated bed. 

The instructions still leave a lot out. I had to reposition a motor bracket three times because the picture/description was not clear enough. It's coming along though. This thing is a tank. Very heavy.


I just hope all this work pays off with great prints.

Files

Previews only

Comments

Anonymous

When you get ready to print, I suggest that you use Olive Oil so that the filament doesn't get stuck in the extruder. This is where I ran into problems.

elproducts

I will keep that in mind, but I plan to test ABS first. Same filament I use in the Fabrikator Mini, left over DaVinci filament.

Anonymous

Nice work! Thanks for putting up a high resolution photo - could zoom in and see some nice detail.