Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Hobbyking.com sent me a new Fabrikator Mini v1.5 for the channel. I'm excited to try it out. It does have some minor changes but my base and LCD holder still fit as seen in the picture. I printed them as I wait for the LCD which I ordered, from the link in my website, to arrive. Then I'll update the firmware for the LCD and put it through its paces and then give a review on the channel.

They also sent me some Colido wood filament to try out. I may use that to make some new knobs for my shop cabinets. It looks like nice filament to try.

Files

Previews only

Comments

Ferdinand Keil

Bought one too after seeing the positive reviews. After printing two test cubes the motors for the x- and y-axis over-heated and melted their mounts. Now the y-axis is unable to return to its home position :( Still arguing with Hobbyking over my RMA case... Anyway, the motors got too hot because of the drive current being too high. They get dialed in with the small pots on the PCB. Make sure yours are set correctly or you might run into the same problems.

Anonymous

Good for you! I almost pulled the trigger on one. Twice actually - but then I pulled out a ruler and looked at the print area. Just too many things I need would not be a fit. It would be nice to get better prints than what the Da Vinci can do. Thinking about just replacing the Da Vinci hot end with an E3D V6 rather than getting another printer. Anyway - look forward to you putting the little beasty through it paces - is the 1.5 as good as the original???? Seems to be some indication it may not be ...............

elproducts

I bought it to travel with. Now it's become my go to printer for small detail prints which is amazing how many times its "big enough".