Watch The Hot End (Patreon)
Published:
2016-04-03 03:50:59
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
Ok, I was just joking about Anthony "The Hot End" being at fault. It was just one of those days so I tried to have some fun with it and give a fellow 3D friend a little friendly jab. I decided after posting to just walk away and get some other work done around the house. I'm trying to finish my basement so I put a few hours in on that project. I came back many hours later and my MAKERFRONT was still cranking away on a future Filament Friday print without issue.
I also heard some people are finding a way to get the fish to print properly on the Jr. There may be a work around for this low cost printer. I'm going to investigate further. This is very encouraging. So the Karma has shifted. Anthony is off the hook. Now go watch his YouTube channel and give him some subs.
Files
Previews only