Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I finally finished the Tarantula 3D Printer Kit. It really wasn't a difficult kit to put together, at least the first half, but it's not for the beginner. They include a nice picture based manual but about half-way through the build it just stops. No next steps, no second manual, nothing. I thought maybe I just didn't get part two but after emailing with a few Tarantula experts, they said the first-half manual was all there was, and that was an upgrade from where it started. There are now some great step by step YouTube videos put together by YouTuber ArcadEd who has apparently built a few of these.

With the help of those videos, I was able to get it together and found out the firmware, already installed on the control board, homed the build plate in the wrong Y direction. I thought I had done something wrong installing the motor on the wrong side but I had it right per the directions and someone had released an updated Firmware that drove the motor the proper way plus some other fixes on the Facebook group. So I decided to just install that rather than swap the motor around. 


The firmware loaded fine but after, the SD card wasn't being recognized. A little more back and forth with the Facebook group, lots of looking through the Marlin Firmware in Arduino along with a couple other firmware downloads didn't solve the problem. I decided to go back to the original updated version with the motor direction fix and this time the SD card worked. I still don't know what was different but I was getting frustrated so I decided to just go with it. It was finally time to make that first print. 


I found a .FFF Simplify 3D profile file on the Facebook group file share and used that to slice my infamous Chess Pawn. I loaded it up and after several adjustments to the bed height, the pawn printed very nice and round with very few flaws. The body of it was a bit wavy which I believe is related to the upper portion of the printer not being stable enough. Their are some strengthening brackets included that I did not install and those clearly are needed. The S3D .FFF file positioned home in the front instead of the back and the start of the print wasn't perfectly centered so I need to adjust the offsets in the profile. I'll save that for a future fix.


Overall I think this is a good printer kit for the money but needs a little more development time. I bought it mainly for the parts. I want to build a larger printer and this kit gives me 75% of the pieces I'll need. So I'll be tearing it apart at some point in the future to build bigger but for now, it will be a another 3D printer to play with. Not that I needed it. This is probably the last kit I'm going to build. Its fully assembled or a custom design only from now on.

Files

Previews only

Comments

Brandon Terry

This is gonna sound ridiculous, but I literally just finished my Tarantula kit this morning, lol. Not a bad printer so far, especially for the price. What a weird coincidence.

Anonymous

Nice first print. I just get the impression that that design will be marginal at best, and great place to sink allot of one's spare time trying to improve - - - if one has spare time to sink.