Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I started a large print on my MAKERFRONT I3 style printer and I’ve had issues with the mounting of the Y-Axis stop switch. Occasionally the bed misses it and throws off the starting point of a print. Well it burned me this time, literally!!!

The print had just started and my wife, whose says my printers have a distinct song they play, could tell something was wrong because it wasn't making the proper music and called me out to the garage immediately. I ran to the MAKEFRONT and found the hotend had gone to far to the back of the bed and caught the heated bed wiring and was burning through the insulation. 


It succeeded just as I got there and high current went through the metal frame and found a path to ground through that same Y-Axis switch ground wire. The current was way to high for the wire and it started glowing bright orange as it melted the insulation and began to smoke heavily. I quickly reached for the plug and yanked it out. I was quick enough to save the current from burning through the whole wire. Hopefully it didn't fry anything on the Arduino or shield. I can easily replace the burned section of the switch wire and the heated bed wire also needs new insulation. Time for some heat shrink tubing. After that I'll test it to see if anything else got fried.


If she didn't recognize the noise when she did, I'm sure I would have had a burned down 3D Printer and since it sits on a wooden bench maybe a  lot worse. So learn from my mistake, make sure your bed wiring and hotend can never get together. I'm going to re-route the whole thing and fix that stupid switch mount.

Files

Previews only

Comments

Bob Hager

Chuck, I'll learn from your experience, Ill be printing a bracket for my switch tonight. I have the XL model so my bed is run by a relay from the power supply. You might want to replicate that to protect your board from high bed currents. I'll be adding a fuse to mine tomorrow. Thanks for sharing.