Monoprice Mini First Print (Patreon)
Content
This printer is as good if not a little better than what I expected. It's solid and nice looking. The only flaw I could find was one screw on top had rust on it (see attached picture) so some moisture got to it during shipping apparently.
The SD card had a couple sample print files already sliced and ready to print. The SD card also has Cura and Repetier setup files on it but I plan to use Simplify3D. The printer was advertised to include sample PLA filament but there was none in the box. So I installed the metal arm for holding the filament spool and loaded some green Inland PLA. I clicked on the print menu and the SD card showed the two sample files. I selected the baby elephant and the picture above shows it be filmed for Timelapse.
I'll do a full review on this printer but first impressions are; this is an amazing printer for $199. The bed size is decent and the print quality of the printer so far looks really good. That's it for now. Off to work I go and I'll be back to check on it later.
Files
Previews only