Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I tried printing a large 100mmx100mm x110mm tall box on the MP Select Mini. It showed the same shifting I saw on the elephant but in a repeatable pattern that caused a wave. I contacted  Monoprice, sent them pictures and after about 45 minutes of back and forth all they could offer was to return it for a replacement. I'm going to look to see if something is loose. It's only showing up in the front and back of prints so its something in the bed not the extruder arm. I'll let you know what I find.

Update:

Apparently many believe this is a Malyan M200 rebranded so there may be firmware available and it may just add WIFI based on reports. So this gets better and better. There is also a facebook group for this printer. Thanks to several Patreon Supporters for tipping me off to this.


Firmware:

http://bit.ly/237eoWl


Facebook Group:

https://www.facebook.com/groups/1717306548519045/


Hackaday Review:

http://hackaday.com/2016/06/13/review-monoprice-mp-select-mini-3d-printer/

Files

Previews only