Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Patreon supporter Michelle Creel asked me if I would print this test print on my ROBO3D. Michelle was having issues printing it and wanted my settings. I wanted to help Michelle but right now it appears that I can't. After trying it, I had to share here because I'm confused as well. This print looks awful.

I used Mattercontrol to slice it. I received a T10 tablet from Matterhackers to test out. It's really just a dedicated tablet running Matercontrol but I can also access the internet and download from Thingiverse. It's connected to the ROBO3D so I thought kill two birds with one stone and try out this print.  So I downloaded the file and the set the printing to high resolution which was 0.1 layer height and 25% fill. I used Matterhackers Grey PLA and ran the print. I used this same filament for some of the door hinge guides and it printed fine. This print came out crappy.


I honestly don't know what went wrong. Is it the filament? Is it the Slicer? Is it the printer? Is the operator? (ok maybe its always the operator since I chose the filament, slicer and printer). But what?


I'm going to now use Simplify3D, some Filamentive PLA and the ROBO3D and try this again. I've had good luck with 2 of the 3 so far.

Honestly. I know people are getting good results with this ROBO3D printer but I'm not. I've been holding off on a review because I want to make sure it's not me. I hate the auto bed level. I prefer the manual knobs. I can't use buildtak because the heated nozzle during bed level melts it. I contacted ROBO and they said I could change the start up GCode to shut off the heat before leveling but should I really have to do that?


So I just wanted to give Michelle my current results and also share with other ROBO3D users. Maybe you can print it and share your results. I believe you can post your results on my Patron Post link at the top of this post. So share your print and your settings.


Print File:

http://www.thingiverse.com/thing:704409

Files

Previews only