Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

The resistor checker is already one of my most popular Filament Friday projects. I've seen three remakes of it on Thingiverse and I've heard of a few more. Apparently I'm not the only one who could use a little help reading resistors.

This idea came from an Article I wrote for Nuts & Volts Magazine back in 2006. The article was republished in my book "Getting Started with PICs". If you aren't familiar with what a PIC is, it's a microcontroller similar to the AVR chip in an Arduino module. Before Arduino, most electronic hobby projects used PICs. 


In the 2006 article I made a resistor reader that had a PIC Microcontroller at the heart of it rather than an ohm meter. I had two bent wires to hold and sense the resistor and then the PIC would read the value and light one of four LEDs positioned in front of an empty tray. It was a simple way to sort resistors. I had a bunch of resistors that got mixed together and I knew they were one of four values of resistance. So I built the circuit for my daughter to use and sort them for me. She's in college now (studying engineering) but back then the tester allowed her to sort them for me without any knowledge of what a resistor was. It worked well and she loved it. She kept asking if their were more resistors to sort. When I showed her the new design she knew instantly what it was. She also now knows how to read an ohm meter and also how to read a resistor. Naturally, she had no interest in sorting the pile of resistors for me. She grew out of that desire.


So this project was just a variation off that original article and it turned out to be a handy 3D print for a lot more people than I expected. 

Files

Previews only

Comments

No comments found for this post.