Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I was able to load a gcode file of the chess pawn into the MOD-t but the position was way off to the back corner, the quality was about the same as the New Matter slicer at 0.2 layer. So I tried Makers Muse test cube print but had to slice it in New Matter since the gcode version went off the bed. The picture shows the results. Very stringy but it completed the print. The edges are a bit rough but it completed its first try. I'll keep trying to figure out the gcode settings.

Files

Previews only

Comments

Anonymous

Not bad. Any idea what brand filament was supplied?

Karl Nowakowski

It worth giving it a good go even if just because of the interesting bed driving system.