Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I've had trouble getting consistent prints out of my Wanhao DI3 and finally found the culprit. This hunk of left over plastic stuck between the bottom the PTFE and the nozzle was dried in place. Took 30 minutes to get it out. Heated it up multiple times and could run a nozzle cleaning wire through it but finally got it out with a tiny drill bit hand turned into the hot plastic. Then pulled.

Files

Previews only

Comments

Karl Nowakowski

I had some plastic stuck in the nozzle I just couldn't get out. I ended up holding the nozzle in a pair of pliers and burning it out above a candle. Seam to work ok.

Anonymous

You know, My Da Vinci Pro nozzly has tried to clog a couple of times (3rd party filament and proprietary one), and I executed the cartridge change command while heating the head with my hot air gun so I could check the temperature in the screen. You can manually push filament, or pull it out. I also took the nozzle out and did the same procedure. Seemed to work and I see it as flushing (old colors came out).

elproducts

Nice. I've taken my nozzle apart many times to find plastic lodged in there. Wish it could just unscrew like most hotends.